[CA] NEMA 2000 with ST60 and ST4000+

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] NEMA 2000 with ST60 and ST4000+

02-14-18, 03:25 PM (This post was last modified: 02-15-18 08:53 AM by Chuck - Raymarine - Moderator.)

Post: #3

[email protected] Offline

Junior Member

Posts: 7
Joined: May 2017
Reputation: 0

RE: [CA] NEMA 2000 with ST60 and ST4000+

Thanks Chuck, I believe I'm on the right track from your response. I made a drawing working with my local Raymarine Dealer (I hope it will attach). Can you comment or correct please ? As far as power .. I believe I need to power the ST4000+ drive on it's own, remove the red lead from the Seatalk1 bus and supply the Axiom and Seatalkng bus with 12VDC. Would it be appropriate to use the same breaker with separate fuses for the MFD and Seatalkng bus ? 12VDC A and B on the drawing

Regards, Greg

Attached File(s)
.jpg

axiom9-2.jpg (Size: 173.19 KB / Downloads: 1036)

« Next Oldest | Next Newest »

Messages In This Thread

[CA] NEMA 2000 with ST60 and ST4000+ - [email protected] - 02-06-18, 04:32 PM

RE: [CA] NEMA 2000 with ST60 and ST4000+ - Chuck - Raymarine - Moderator - 02-06-18, 05:13 PM

RE: [CA] NEMA 2000 with ST60 and ST4000+ - [email protected] - 02-14-18 03:25 PM

RE: [CA] NEMA 2000 with ST60 and ST4000+ - Chuck - Raymarine - Moderator - 02-15-18, 09:45 AM

RE: [CA] NEMA 2000 with ST60 and ST4000+ - [email protected] - 02-15-18, 09:34 PM

RE: [CA] NEMA 2000 with ST60 and ST4000+ - Chuck - Raymarine - Moderator - 02-16-18, 08:45 AM

RE: [CA] Axiom 9 / NEMA 2000 with ST60 and ST4000+ - [email protected] - 03-07-18, 12:22 PM

RE: [CA] NEMA 2000 with ST60 and ST4000+ - Chuck - Raymarine - Moderator - 03-07-18, 02:57 PM

User(s) browsing this thread: 4 Guest(s)