[CA] Axiom 9 with Seatalk-SeaTalkng converter

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Jorgen,

The SeaTalk to SeaTalkng Converter should not be expected to appear within the Data Sources List. However, if properly interfaced to the system, then it should appear within the diagnostics of the system's Data Master MFD (HOME->SET-UP->NETWORK->DIAGNOSTICS->VIEW ALL PRODUCTS). As has been indicated within the FAQ found here, it is recommended that autopilots having a SeaTalk communications interface not supply power to the SeaTalk bus when interfaced to a SeaTalk to SeaTalkng Converter.
Instead, the SeaTalk bus will be powered via the SeaTalkng bacbone via the SeaTalk to SeaTalkng Converter. Per the FAQ found here, please note that while the SeaTalk to SeaTalkng Converter is supported for use with the ST4000+ autopilot it is not supported for use with the ST4000. Please additionally be aware that Autopilot Controls feature of MFD's running LH3 software is exclusively designed for use with Evolution autopilots. Accordingly, should the MFD be interfaced to a legacy autopilot, then the autopilot control head's buttons would need to be used to command the autopilot into Standby, Auto, and Track modes, execute +/-1 and +/-10 heading changes, and the configure the autopilot.