Raymarine forum / Raymarine Forums / Instruments v / [CA] i60 True wind not working

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] i60 True wind not working
03-02-18, 01:14 PM (This post was last modified: 03-02-18 02:45 PM by Chuck - Raymarine - Moderator.)
Post: #14
hwturn Offline
Junior Member
**
 		Posts: 4
Joined: Oct 2016
Reputation: 0
RE: [CA] i60 True wind not working
I have done additional troubleshooting. The MFD is not seeing anything on the network. I have swapped out the Sea Talk 3 way for a new one...no impact.
I have tried the discovery mode on the MFD and it doesn't find anything on the network. I even swapped out the Sea Talk Coverter and ran 12v directly to it and connected only the i60 and MFD. Still nothing on the network. I checked continuity on the Spur cable to the MFD and it looked good, what should the spec resistance be? The MFD has seperate power supply and that checks out good too.
I am not sure I understand the autopilot question. Would Autohelm type 100 be an option? for 3 years the system as set up in this configuration worked fine. Then just one day is stopped. It looks to be the network or a connector and not just the wind unit.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] i60 True wind not working - hwturn - 10-14-17, 04:05 PM
RE: [CA] i60 True wind not working - hwturn - 03-02-18 01:14 PM

Forum Jump:


User(s) browsing this thread: 4 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication