(DG) Installing new Raymarine products

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

(DG) Installing new Raymarine products

03-08-18, 06:57 AM

Post: #4

Derek - Raymarine - Moderator Offline

Administrator

Posts: 1,416
Joined: Nov 2017
Reputation: 9

RE: (DG) Installing new Raymarine products

Hi Kurt Warneke

Thanks for the updated schematic, you are very nearly correct!

The only change you need to make now is to disconnect the SPUR cable connected to NET on your diagram and reconnect that same spur to the NMEA2000 connector on the AXIOM 9 PRO, then you are all set.

regards

« Next Oldest | Next Newest »

Messages In This Thread

(DG) Installing new Raymarine products - Kurt Warneke - 03-06-18, 04:41 PM

RE: (DG) Installing new Raymarine products - Derek - Raymarine - Moderator - 03-07-18, 07:21 AM

RE: (DG) Installing new Raymarine products - Kurt Warneke - 03-07-18, 05:29 PM

RE: (DG) Installing new Raymarine products - Derek - Raymarine - Moderator - 03-08-18 06:57 AM

RE: (DG) Installing new Raymarine products - Kurt Warneke - 03-08-18, 06:18 PM

RE: (DG) Installing new Raymarine products - Derek - Raymarine - Moderator - 03-09-18, 05:46 AM

User(s) browsing this thread: 3 Guest(s)