[CA] Possible CPT-200 Transducer Low Voltage Issue

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] Possible CPT-200 Transducer Low Voltage Issue

03-19-18, 12:22 PM

Post: #4

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: [CA] Possible CPT-200 Transducer Low Voltage Issue

Tom,

The symptom which you have described is normal. The specified alert will be displayed if CP200 is powered ON after the MFD has completed its startup initialization. Clearing the alert will then permit SideVision sonar imaging to proceed. This message would not typically be encountered if the MFDs and CP200 were switched ON at the same time.

« Next Oldest | Next Newest »

Messages In This Thread

[CA] Possible CPT-200 Transducer Low Voltage Issue - chartertom - 03-19-18, 08:06 AM

RE: [CA] Possible CPT-200 Transducer Low Voltage Issue - Chuck - Raymarine - Moderator - 03-19-18, 10:24 AM

RE: [CA] Possible CPT-200 Transducer Low Voltage Issue - chartertom - 03-19-18, 12:01 PM

RE: [CA] Possible CPT-200 Transducer Low Voltage Issue - Chuck - Raymarine - Moderator - 03-19-18 12:22 PM

RE: [CA] Possible CPT-200 Transducer Low Voltage Issue - chartertom - 03-19-18, 12:32 PM

RE: [CA] Possible CPT-200 Transducer Low Voltage Issue - Chuck - Raymarine - Moderator - 03-19-18, 01:20 PM

User(s) browsing this thread: 1 Guest(s)