The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] Axiom 9 Power Swipe

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom 9 Power Swipe
03-26-18, 11:21 AM (This post was last modified: 03-28-18 12:31 PM by Chuck - Raymarine - Moderator.)
Post: #1
Jeff-LE Offline
Junior Member
**
 		Posts: 1
Joined: Mar 2018
Reputation: 0
[CA] Axiom 9 Power Swipe
I have seen a number of posts here regarding power swipe issues with no real resolution. We have purchased a total of 4 Axiom 9's (purchased 2 and then exchanged for 2 new ones) and all have had issues with the device not responding to a power swipe after being on for a while for most and one of them if left alone for even an hour it will not respond to the power swipe. These are brand new units, just unboxed 2 days ago. If you remove power for a minute and reconnect, the power swipe works fine for a limited time then becomes unresponsive again. This would seem to indicate that this is a software/firmware issue. All of the units are running lighthouse 3.3.170. We purchased these for the express purpose of controlling a FLIR M232. Without an immediate solution to this problem we will be forced to return these two and switch to third party MFD's to control the M232. These are installed on a climate controlled wheelhouse with clean 12v power.

Thanks,
Jeff
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Axiom 9 Power Swipe - Jeff-LE - 03-26-18 11:21 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication