The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] Axiom 7 and Axiom 9 Setup

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom 7 and Axiom 9 Setup
04-30-18, 08:39 AM (This post was last modified: 04-30-18 04:00 PM by Chuck - Raymarine - Moderator.)
Post: #1
Solo_Cam21 Offline
Junior Member
**
 		Posts: 17
Joined: Mar 2017
Reputation: 0
[CA] Axiom 7 and Axiom 9 Setup
Hi Support,

I have added an Axiom 7 surfaced mounted to my boat and linking it with the Axiom 9. Currently I have an installed Nav card in the Axiom 9 and also have a newer Navionics card to be installed. My questions below:

1) On my existing Axiom 9 unit I have the old card with saved waypoints. What would the best practice be to move over to the new card?

2) Would it be better to keep my old card in the one unit and just install the new card in the Axiom 7 since they are linked?

3) Last, I'm going to upgrade the units once install is finished to the latest firmware. Do I need a memory card in each unit to do this?


Thank you for your assistance.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Axiom 7 and Axiom 9 Setup - Solo_Cam21 - 04-30-18 08:39 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication