[CA11] Axiom Realvision 3d issue

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Axiom Realvision 3d issue

04-30-18, 09:36 AM (This post was last modified: 07-30-18 02:34 PM by Chuck - Raymarine - Moderator.)

Post: #1

Reach50 Offline

Junior Member

Posts: 1
Joined: Apr 2018
Reputation: 0

[CA11] Axiom Realvision 3d issue

I have only had my Axiom installed for 3 outings so far. And for some reason the 3d sonar channel always shows almost a wall coming from directly below the boat and coming straight up to the surface on the right side of the boat. 90% of the time the left side is blank and when it does display a bottom it only shows maybe 10 feet to the left. There is nothing around the transducer blocking it and it is level. The other sonar channels appear to be operating normally. Any thoughts?
Picture

http://imgur.com/WinrEDR

Thanks

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Axiom Realvision 3d issue - Reach50 - 04-30-18 09:36 AM

RE: [CA11] Axiom Realvision 3d issue - Chuck - Raymarine - Moderator - 05-08-18, 03:36 PM

RE: [CA11] Axiom Realvision 3d issue - mark d - 07-29-18, 02:23 AM

RE: [CA11] Axiom Realvision 3d issue - Chuck - Raymarine - Moderator - 07-30-18, 08:12 AM

User(s) browsing this thread: 3 Guest(s)