[CA] Creating autoroute a78

[Chuck - Raymarine - Moderator]

Jeff,

I was unable to duplicate the problem when tested within an a-Series MFD (v19.03), Navionics Platinum Plus chart card, and using it's menu option to Place Waypoint. After placing the first waypoint, each time thereafter that the Place Waypoint menu item was selected, the Chart application autorouted to the location of the placed waypoint. Please note that when the Build Route's Dock to Dock Autorouting menu item is switched OFF, then the MFD will produce a simple two-point route between the two waypoints. This same condition will also occur if the Chart application is unable to produce the autoroute due to insufficient depths at the starting, ending, or waters in between, or the chart card does not have an active Navionics Freshest Data subscription.

Should you have not already done so, then it would be recommended that the chart card's contents be erased using the Navionics Chart Installer program, and that the chart cards contents then be updated with Freshest Data updates (both Nautical Charts and SonarCharts) for the maximum size permitted by the Navionics Chart Installer, given the chart card's capacity.