[CA11] Can't setup ITC-5 from i70s.

[Chuck - Raymarine - Moderator]

Nokay,

Thanks for providing the system diagram and software level of the iTC-5. It is recommended that i70S MFID's software level be determined and if found to be earlier than v3.11, that its software be updated. Should the problem persist thereafter, then it would be recommended that all third party products be temporarily unplugged from the SeaTalkng / NMEA 2000 backbone and that the i70S then be tested again. Should the Transducer Setup continue to not permit selection of wind, speed, and temperature persist when so configured, then it would be recommended that a Factory Reset be commanded to the i70S MFID to correct the reported issue. Should the problem persist, then use the Diagnostics feature of the i70S to determine the software versions of the other Raymarine products within the system. Should any of them be determined to not be current, then the software within these devices should be updated accordingly.