The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [CA] [CA11] ST60 wind vane issue

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] ST60 wind vane issue
05-31-18, 03:39 PM (This post was last modified: 06-01-18 01:37 PM by Chuck - Raymarine - Moderator.)
Post: #1
hkapanen Offline
Junior Member
**
 		Posts: 1
Joined: May 2018
Reputation: 0
[CA11] ST60 wind vane issue
Hello,

I have a faulty ST60 wind transducer. I took it apart and powered the PCB with a lab power (8V between red and screen wires). When probing directional signals (blue & green) with an oscilloscope, they appear to output 2-6V sin & cosine which I believe is correct. However, anemometer signal (yellow) outputs approx 350mV pulses while I believe the pulse amplitude should be 5V. Can you please confirm that this is faulty behaviour. If so, please advice on remedy.

Many thanks,

Harri
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] ST60 wind vane issue - hkapanen - 05-31-18 03:39 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication