Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Upgrading from an E80 to Axiom 12
06-04-18, 09:44 AM (This post was last modified: 06-04-18 09:47 AM by Chuck - Raymarine - Moderator.)
Post: #4
RE: [CA11] Upgrading from an E80 to Axiom 12
carlmk,

Please click here to view a FAQ addressing replacement of an E-Series Classic MFD with an Axiom MFD. As you have SeaTalk instruments and a compatible (w/ST-STng Converter) autopilot course computer which has been interfaced an autopilot control head having a SeaTalk communications interface, a SeaTalk to SeaTalkng Converter will be used to interfaced the ST60 Instruments and SPX autopilot course computer (to continue being installed as a SeaTalk device), and ST6000+ autopilot control head to the Axiom MFD. Please see the SeaTalk section (included link to corresponding FAQ) of the FAQ referenced above regarding how to interface your legacy Raymarine products to the system. The SPX autopilot course computer's SeaTalkng Power Switch should also be configured to the OFF position.

As Axiom MFDs feature a single Ethernet communications port, should a wired data connection to the Quantum radome be planned, then it would be necessary to install a HS5 RayNet Network Switch, to which the MFD, Quantum radome, and SR150 SiriusXM Satellite Weather / Radio Receiver would each be interfaced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Upgrading from an E80 to Axiom 12 - Chuck - Raymarine - Moderator - 06-04-18 09:44 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)