European Union (.eu)
United States (.com)
United Kingdom (.co.uk)
Australia (.com.au)
Denmark (.dk)
Finland (.fi)
France (.fr)
Germany (.de)
Italy (.it)
Norway (.no)
Netherlands (.nl)
Spain (.es)
Sweden (.se)
Search
Member List
Calendar
Help
Raymarine forum
/
Raymarine Forums
/
Autopilots 
/
[TG11] Use Type 3 Hydraulic Pump With a 255 cm3 Cylinder
/
[TG11] Use Type 3 Hydraulic Pump With a 255 cm3 Cylinder
|
[TG11] Use Type 3 Hydraulic Pump With a 255 cm3 Cylinder
|
|
06-12-18, 07:03 PM
Post: #8
|
|||
|
|||
|
RE: [TG11] Use Type 3 Hydraulic Pump With a 255 cm3 Cylinder
Hello Horacio,
Those estimates are essentially based on vessel displacement rather than drive size (it takes roughly the same energy to push the rudder on a 11,00kg vessel whatever suitable drive type you do it with.) We can't give estimates based on vessel displacement when it comes to hydraulic pilots though because the pump is specified on the basis of cylinder size, not vessel weight. If you look at your attached table and compare the vessel displacements for the Linear drives to your own boat, that will give you a reasonable idea of the consumption to expect from your hydraulic system. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)