Threaded Mode | Linear Mode

***Chuck - Raymarine - Moderator*** · 05-02-16, 01:58 PM

Navatech,

Q1. If I chose to purchase an a67 MFD I'd need a E66066 connector cable to make use of this transducer?
A1. Correct. This combination will drive the specified 1kW transducer with 600W to support sonar operation in depths up to 800'.

Q2. And, if I chose either the e125 or the e127 I'd need to add a DSM300 to make use of this transducer?
A2. Partially correct. Should and e127 MFD be installed, then you will need a E66066 connector cable to make use of this transducer. This combination will drive the specified 1kW transducer with 600W to support sonar operation in depths up to 800'. Should an e125 MFD be installed, then you'll need to additionally install a CP370, CP300, DSM300 to drive the 1kW transducer with 1kW, increasing the maximum operational depth of the sounder. As the CP300, DSM300, and DSM30 are no longer manufactured, a CP370 would be required should an ax5/cx5/e7/ex5/eSx5/gSx5 MFD be installed on the vessel.