Raymarine forum / Raymarine Forums / AIS v / [CA] [CA11] Using proAIS2 with AIS500 transceiver

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Using proAIS2 with AIS500 transceiver
06-17-18, 08:52 PM
Post: #9
dantos Offline
Junior Member
**
 		Posts: 9
Joined: Apr 2018
Reputation: 0
RE: [CA11] Using proAIS2 with AIS500 transceiver
Hi Chuck,

I finally got to the boat with my laptop today, but ran into a couple of error messages on which I would appreciate your advice.

When I connected to my AIS500 transceiver with the ProAIS software on my laptop, I received the following:
"No Unit Detected on COM3. Please check power and data connection".

I then tried on ProAIS2, and got:
"Status: Determining the AIS device type".

Any suggestions? Is it the USB to RS232 connection, or something else......

Thanks so much for your assistance.

Kind regards,

David
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Using proAIS2 with AIS500 transceiver - dantos - 06-17-18 08:52 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication