[CA11] Adding A50 chartplotter to Evolution Pilot

Thread Rating:

1 Vote(s) - 3 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Adding A50 chartplotter to Evolution Pilot

06-21-18, 08:09 AM

Post: #2

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: [CA11] Adding A50 chartplotter to Evolution Pilot

Welcome to the Raymarine Forum Eugene,

You may be making this task more complicated than it need be. I would recommend simply replacing the SeaTalkng T-Piece with an A06064 SeaTalkng 5-Way Connector. Doing so would permit up to three spurs to be connect to the backbone where the T-Piece is presently located. Please additionally be aware that the maximum total cable length of a spur cannot exceed 6m.

The ACU-100 is not designed to supply power to a SeaTalkng / NMEA 2000 backbone.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Adding A50 chartplotter to Evolution Pilot - Eugene323 - 06-18-18, 02:59 PM

RE: [CA11] Adding A50 chartplotter to Evolution Pilot - Chuck - Raymarine - Moderator - 06-21-18 08:09 AM

RE: [CA11] Adding A50 chartplotter to Evolution Pilot - Eugene323 - 06-22-18, 02:36 PM

RE: [CA11] Adding A50 chartplotter to Evolution Pilot - Chuck - Raymarine - Moderator - 06-22-18, 03:45 PM

RE: [CA11] Adding A50 chartplotter to Evolution Pilot - Eugene323 - 06-22-18, 04:43 PM

RE: [CA11] Adding A50 chartplotter to Evolution Pilot - Chuck - Raymarine - Moderator - 06-25-18, 08:43 AM

User(s) browsing this thread: 1 Guest(s)