Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] RAYMARINE AXIOM ERROR CANT FIND TRANSDUCER
07-05-18, 12:03 PM
Post: #2
RE: [CA11] RAYMARINE AXIOM ERROR CANT FIND TRANSDUCER
Welcome to the Raymarine Forum Mike,

Unless the transducer's cable has been spliced (strongly discouraged), then it should have only been necessary to plug the cables back into the corresponding sockets of the MFD. While I am aware that you have performed a sonar reset, I can only advise that the MFD's be switched OFF, that the cables be unplugged from the MFD(s), that their plugs then be re-seated within the corresponding sockets of the MFD(s), that the locking ring for each plug then be rotated into the locked position, and that the system then be tested again. Should the problem persist, then it would be recommended that a Factory Reset (HOME->SETTINGS->THIS DISPLAY->FACTORY RESET) be performed, that the system be reconfigured (note that no transducer need be specified for RealVision 3D, SideVision, DownVision, or high CHIRP conical sonar) as the MFD will automatically recognize and utilize the connected RV transducer.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] RAYMARINE AXIOM ERROR CANT FIND TRANSDUCER - Chuck - Raymarine - Moderator - 07-05-18 12:03 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)