The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Instruments v / [TG] Connection I-60 to VDR/ECDIS NMEA0183

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] Connection I-60 to VDR/ECDIS NMEA0183
07-10-18, 09:59 AM (This post was last modified: 07-19-18 02:02 AM by Tom - Raymarine - Moderator.)
Post: #1
Anderson.mackay Offline
Junior Member
**
 		Posts: 1
Joined: Jul 2018
Reputation: 0
Connection I-60 to VDR/ECDIS NMEA0183
Hello dears

I have a job to perform on a vessel which was installed a i60 Wind Instrument.
After the installation some equipments which are connected on the i60 are missing the wind sensor signal (e.g. VDR/ECDIS). These equipments receive only NMEA 0183 signals.
It was found on board also the NGW 1 Actisense adaptor to NMEA 0183 installed but the equipments still missing the signal of wind.
I put in attached the installation that i found on board.
Can you help me with that ?
It is necessary to install/configure something else to work ?

Thanks in advance,

Anderson.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Connection I-60 to VDR/ECDIS NMEA0183 - Anderson.mackay - 07-10-18 09:59 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication