[CA11] Airmar UDST800

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Airmar UDST800

07-24-18, 02:31 PM (This post was last modified: 07-24-18 02:41 PM by Chuck - Raymarine - Moderator.)

Post: #1

tahoeretreat Offline

Junior Member

Posts: 4
Joined: Feb 2016
Reputation: 0

[CA11] Airmar UDST800

I was hoping to use my new Airmar UDST800 to replace the existing DST800 used on my boat with the A70 display. This is a NMEA2000 interface ... however I'm not sure this is supported as it is not configurable as a source on the i70 instrument (it does display under Devices Found as an "25-1110-01,HW3:14,OEM0" on the unit.). Can this work? Do i need to upgrade to an Axiom from the legacy A10? Please advise.

Thank you,
Jim

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Airmar UDST800 - tahoeretreat - 07-24-18 02:31 PM

RE: [CA11] Airmar UDST800 - Chuck - Raymarine - Moderator - 07-24-18, 03:22 PM

RE: [CA11] Airmar UDST800 - tahoeretreat - 07-31-18, 09:22 AM

RE: [CA11] Airmar UDST800 - Chuck - Raymarine - Moderator - 08-01-18, 08:05 AM

RE: [CA11] Airmar UDST800 - tahoeretreat - 08-03-18, 09:33 AM

RE: [CA11] Airmar UDST800 - tahoeretreat - 08-20-18, 11:34 PM

RE: [CA11] Airmar UDST800 - Chuck - Raymarine - Moderator - 08-21-18, 07:41 AM

User(s) browsing this thread: 2 Guest(s)