[CA11] Axiom Realvision 3d issue

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Axiom Realvision 3d issue

07-29-18, 02:23 AM (This post was last modified: 07-30-18 02:34 PM by Chuck - Raymarine - Moderator.)

Post: #3

mark d Offline

Junior Member

Posts: 13
Joined: May 2018
Reputation: 0

RE: [CA11] Axiom Realvision 3d issue

I have experienced the same "wall" to the starboard side, I then set the range to manual, so in 12 meters of water I set the range to 35 mt and as a result got a nice uncluttered image.

The signal must be weighted to depth in auto I think.
Hope this helps
Mark

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Axiom Realvision 3d issue - Reach50 - 04-30-18, 09:36 AM

RE: [CA11] Axiom Realvision 3d issue - Chuck - Raymarine - Moderator - 05-08-18, 03:36 PM

RE: [CA11] Axiom Realvision 3d issue - mark d - 07-29-18 02:23 AM

RE: [CA11] Axiom Realvision 3d issue - Chuck - Raymarine - Moderator - 07-30-18, 08:12 AM

User(s) browsing this thread: 1 Guest(s)