Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Loss of range rings
07-31-18, 08:25 AM (This post was last modified: 08-03-18 12:49 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] Loss of range rings
Welcome to the Raymarine Forum halfwaytoo,

It is recommended that you verify that the system has acquired a GPS position FIX from the select GPS Data source. If so, then Range Rings may be viewed when the Chart application has been configured to DETAILED. When configured to Simple, Weather, or Fishing Chart, then range rings will not be displayed. After doing so, command sequence MENU->LAYERS->RANGE RINGS may be used to configure the range rings ON/OFF. Should the recommendations specified above failed to permit range rings to be displayed when viewing the Detailed chart, then it would be recommended that a Factory Reset (HOME->SETTINGS->THIS DISPLAY->FACTORY RESET be commanded to address the reported symptom.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Loss of range rings - halfwaytoo - 07-30-18, 04:28 PM
RE: [CA11] Loss of range rings - Chuck - Raymarine - Moderator - 07-31-18 08:25 AM

Forum Jump:


User(s) browsing this thread: 5 Guest(s)