[CA] [CA11] EV1 Linearization via e7 MFD or ST6002

[Thombusc]

Well, that is quite helpful. However, instead of showing what the disply on the e7 when discussing linearization it shows the p70 screen. The P70 shows a progress bar that is displayed during the linearization process and a nice "OK" notification with the deviation shown when it has been completed.
http://forum.raymarine.com/attachment.php?aid=2173

Does anything like this happen in the e7 display? If so, where. If not, it should probably be included in the next software update. ;)

I did check via the e7 and the pilot shows a 16 degree deviation. So, if that is that my only remaining question is,

If I do not lock the compass will the deviation continue to be updated as we sail on?

thx

(08-02-18 12:58 PM)Chuck - Raymarine - Moderator Wrote:  As indicated within the Linearization section of Chapter 7.11, a dialog will be displayed upon completion of linearization listing the maximum detected deviation. As indicated, the maximum detected deviation will also be listed within the Pilot Set-up dialog.