The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Losing the GPS Signal and "Go To" Function

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Losing the GPS Signal and "Go To" Function
08-09-18, 02:31 PM (This post was last modified: 08-15-18 12:19 PM by Chuck - Raymarine - Moderator.)
Post: #1
carlmk Offline
Junior Member
**
 		Posts: 42
Joined: Oct 2017
Reputation: 0
[CA11] Losing the GPS Signal and "Go To" Function
I have been using my newly installed Axiom Pro 12 and Axiom 9 system very successfully, However, occasionally the GPS signal drops out; it comes back quickly.

When the GPS signal drops out the alarm goes off indicating this, but it is so brief I often miss it. It is briefer than the "next waypoint" alarm. In addition, there is no "acknowledge" flag shown on the screen. The "go to" function stops and its only indication is the BTW data drops out.

Is there something I am doing wrong? It would be nice if the alarm was longer and an "acknowledge" flag was shown on the screen.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Losing the GPS Signal and "Go To" Function - carlmk - 08-09-18 02:31 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication