[CA11] Installing evo400 on a steel hull sailboat

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Installing evo400 on a steel hull sailboat

08-15-18, 04:40 PM (This post was last modified: 08-16-18 10:15 AM by Chuck - Raymarine - Moderator.)

Post: #3

[email protected] Offline

Junior Member

Posts: 11
Joined: May 2017
Reputation: 0

RE: [CA11] Installing evo400 on a steel hull sailboat

Dear all,
I have a question, since I have to mount the ev1 sensor on the aluminum mast, since I have got a steel sailboat.
Inside the mast there are electric cables of the navigation lights and of the radar, in addition to the vhf antenna cable.
In the istructions about the location of the sensor I read: "The unit must be at least 1 m (3 ft.) away from any source of magnetic interference, such as compasses and electrical cables."
Can you tell me how to do?

Best regards,
Maurizio

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Installing evo400 on a steel hull sailboat - george123 - 10-07-16, 05:17 PM

RE: [CA11] Installing evo400 on a steel hull sailboat - Chuck - Raymarine - Moderator - 10-10-16, 10:21 AM

RE: [CA11] Installing evo400 on a steel hull sailboat - [email protected] - 08-15-18 04:40 PM

RE: [CA11] Installing evo400 on a steel hull sailboat - Chuck - Raymarine - Moderator - 08-16-18, 08:20 AM

User(s) browsing this thread: 1 Guest(s)