Merc Gateway PNG Conflict - NEW SOFTWARE REQUESTED

[[email protected]]

Hello Raymarine,

I'm using the E95 running latest software.
Attached to the Seatalk NG (NMEA2000):
- Merc Gateway (engine data)
- Lenco AutoGlide

Both devices are reporting on PNG 130576
Merc is transmitting 0 (No Trimtab connected to the engine)
Lenco is reporting the proper Trimtab position

So the problem is when the engines are turn ON, both devices (Lenco & Merc Gateway) are reporting the Trimtabs position. Because both device are reporting different value, the E95 is just flashing between the values.

The "Data Source" feature has been add for other sensors such as Depth, Water Temp... It appear the TrimTabs has been forgotten.

Would it be possible to add in the next software upgrade a "Data Source" for the Trimtab feature ?

Thanks in advance
David