[DG] [DG] ST6000 installation

[Derek - Raymarine - Moderator]

Hi Minimage

Thank you for your enquiry.

NO LINK indicates that the control unit has no comms with the course computer, it could be a sign that the entine SeaTalk network has crashed or just that there is a fault with the Autopilot.

Start by disconnecting everything from SeaTalk other than the St6000 control head and keep this wire as short as possible, check there are no shorts or stray wires to the SeaTalk connections.

If the fault disappears when the other equipment is connected, then gradually reconnect the other units until the fault reoccurs, this will then identify the faulty unit or cable.

If the fault remains when the autopilot is isolated, then there is a fault with the control unit or with the course computer, spares for this age of product are few and far between, you could return it to one of our approved service dealers, but even so, it may even be unrepairable.

regards
Derek