[DG] Rudder sensor with ACU-300

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG] Rudder sensor with ACU-300

08-24-18, 04:04 PM (This post was last modified: 08-28-18 11:17 AM by Derek - Raymarine - Moderator.)

Post: #1

[email protected] Offline

Junior Member

Posts: 11
Joined: May 2017
Reputation: 0

[DG] Rudder sensor with ACU-300

Dear all

I have read in ACU-300 manual that the rudder sensor connection is recommended, but not mandatory.
In appendix B of the manual I have read also that the message number 127245 "Rudder Angle" is both transmitted and received.
This means that I can leave the rudder sensor connected to the iTC-5, so I can read the rudder angle even when the ACU-300 is in sleep mode, and the ACU-300 can have the info of rudder angle from iTC-5 via STng when it's working.

Could you please confirm my assumption?

Best regards
Maurizio

« Next Oldest | Next Newest »

Messages In This Thread

[DG] Rudder sensor with ACU-300 - [email protected] - 08-24-18 04:04 PM

RE: [DG] Rudder sensor with ACU-300 - Derek - Raymarine - Moderator - 08-28-18, 11:21 AM

RE: [DG] Rudder sensor with ACU-300 - [email protected] - 08-30-18, 08:22 AM

RE: [DG] Rudder sensor with ACU-300 - Derek - Raymarine - Moderator - 08-30-18, 10:03 AM

User(s) browsing this thread: 1 Guest(s)