[CA11] Using an old transducer with a new plotter

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Using an old transducer with a new plotter

10-05-18, 10:59 AM (This post was last modified: 10-05-18 02:46 PM by Chuck - Raymarine - Moderator.)

Post: #1

spellegrin Offline

Junior Member

Posts: 8
Joined: Oct 2018
Reputation: 0

[CA11] Using an old transducer with a new plotter

I'm replacing my E120W with an Axiom Pro 12 RVX and would like, in the short term, to continue to use my existing sonar transducer. The transducer is part number E66086, sometimes called a B60. I've been advised that this is possible using adapter cable A80496.

But I'm not so sure. My concern is that the Axiom Pro has 1kW output and the transducer is only rated for 600 watts.

Do you think that this solution will work without blowing out my transducer? If not, can you recommend another way to make my new plotter work with my old transducer?

Thanks in advance for any help you can provide.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Using an old transducer with a new plotter - spellegrin - 10-05-18 10:59 AM

RE: [CA11] Using an old transducer with a new plotter - Chuck - Raymarine - Moderator - 10-05-18, 02:52 PM

RE: [CA11] Using an old transducer with a new plotter - spellegrin - 10-05-18, 05:01 PM

RE: [CA11] Using an old transducer with a new plotter - Chuck - Raymarine - Moderator - 10-08-18, 11:09 AM

RE: [CA11] Using an old transducer with a new plotter - spellegrin - 10-08-18, 11:45 AM

RE: [CA11] Using an old transducer with a new plotter - Chuck - Raymarine - Moderator - 10-08-18, 12:15 PM

RE: [CA11] Using an old transducer with a new plotter - spellegrin - 11-08-18, 07:09 PM

User(s) browsing this thread: 1 Guest(s)