Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] SPX30 resets STng network when switched on

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] SPX30 resets STng network when switched on
10-10-18, 02:49 PM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] SPX30 resets STng network when switched on
Welcome to the Raymarine Forum jfitch,

The current version of each device which has been interfaced to the SeaTalkng / NMEA 2000 backbone may be determined by executing the command sequence MENU->SET-UP->DIAGNOSTICS->ABOUT SYSTEM on the autopilot control head. It is recommended that you verify that each device within the SeaTalkng backbone has been updated with the latest available Raymarine product software updates, and if not, that the software within any device which is not current be updated accordingly. Should the problem persist thereafter, then it would be recommended that the autopilot course computer be sent to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] SPX30 resets STng network when switched on - Chuck - Raymarine - Moderator - 10-10-18 02:49 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication