[DG] Autohelm multi display asking for a code on power up

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[DG] [DG] Autohelm multi display asking for a code on power up

10-15-18, 08:56 AM

Post: #4

Derek - Raymarine - Moderator Offline

Administrator

Posts: 1,416
Joined: Nov 2017
Reputation: 9

RE: [DG] Autohelm multi display asking for a code on power up

Hi sbeeler333

If the system is asking for a code since you removed a display, then the display that was removed was likely the MASTER, OR the replacement display you fitted was not a master and so is looking for a code from the old system.

The old code of 0000 should be able to be deleted, make sure that you press the DEPTH button briefly and quickly after you see the Software code, if you pause too long it will exit the code mode and return you to the Depth menu for alarm selection.

I suggest you need to experiment with button pressing to access the codelock menus.

regards
Derek

« Next Oldest | Next Newest »

Messages In This Thread

[DG] Autohelm multi display asking for a code on power up - [email protected] - 07-05-18, 08:59 AM

RE: [DG] Autohelm multi display asking for a code on power up - Derek - Raymarine - Moderator - 07-06-18, 11:43 AM

RE: [DG] Autohelm multi display asking for a code on power up - [email protected] - 10-15-18, 08:22 AM

RE: [DG] Autohelm multi display asking for a code on power up - Derek - Raymarine - Moderator - 10-15-18 08:56 AM

RE: [DG] Autohelm multi display asking for a code on power up - [email protected] - 10-15-18, 09:14 AM

RE: [DG] Autohelm multi display asking for a code on power up - Derek - Raymarine - Moderator - 10-15-18, 09:22 AM

User(s) browsing this thread: 1 Guest(s)