The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Installation Diagram

Post Reply 
 
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Installation Diagram
10-28-18, 09:19 PM (This post was last modified: 10-29-18 10:35 AM by Chuck - Raymarine - Moderator.)
Post: #1
Metxxx69 Offline
Junior Member
**
 		Posts: 5
Joined: Nov 2017
Reputation: 0
[CA11] Installation Diagram
Very Good Night Raymarine Support Dept.

I need your help in a diagram of installation to know what connector or cable I need to make my installation correct, I have a 42-foot yacht with 3 outboard motors Mariner Verado 400, These are the equipment that I have and I want to leave connected and working properly.

E70345 Ray52 VHF Radio GPS Receiver 2
E70369-03-LNC AXIOM 12 RV 600W Sonar 1
E70368-00-LNC AXIOM 12 Multifunction Display 2
A80007 HS-5 Network Switch (RayNet) 1
T70157 EV-200 Hydraulic Autopilot 1
A62361 RayNet (F) to RayNet (F) cable - 2m. 1
T70408 4kW Magnum with 48" Open Array 1
E70354 M232 Pan and Tilt Thermal Camera. 1
T70327 RS150 GPS Antenna, w/Pole Mount Kit. 1

These are the equipment, what I would like to know is if I need some kind of switch or cable to leave everything ready in the shortest possible time.

Thanks for your help, and great support!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Installation Diagram - Metxxx69 - 10-28-18 09:19 PM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication