Display Generator Data

[Chuck - Raymarine - Moderator]

jeokeefe,

The Engines Set-up feature is exclusively designed to be used to configure compatible engines which have been interfaced to the system via an ECI-100 and as such would not be applicable to the generator. Other sources of NMEA 2000 engine data are simply repeated by the MFD. I would expect that should your Maretron J2K100 have been properly configured, be transmitting data to the SeaTalkng/NMEA 2000 backbone, and the MFD have been configured for three engines, then any Data application panel which had been configured to display data from Engine 3 (instance 2) should then display data associated with that engine instance. Troubleshooting should begin by using the NMEA 2000 CAN bus analyzer to verify that the data items which you have specified are indeed present for instance 2. If so, it would be recommended that the MFD's diagnostics features be used to capture/log approximate 30 seconds of SeaTalkng data with all three engines operating. The resulting log may be attached to this discussion for further analysis.