The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [TG] [TG11] Autohelm T300 computer & Raymarine Smart Heading Sensor via NMEA

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Autohelm T300 computer & Raymarine Smart Heading Sensor via NMEA
12-14-18, 03:55 PM (This post was last modified: 12-26-18 11:26 AM by Chuck - Raymarine - Moderator.)
Post: #1
Sailing_Sergio Offline
Junior Member
**
 		Posts: 6
Joined: Nov 2018
Reputation: 0
[TG11] Autohelm T300 computer & Raymarine Smart Heading Sensor via NMEA
Hi,

Would a Autohelm T300 course computer (165P16 software) work without its flux-gate compass if Raymarine Smart Heading Sensor is connected to it via NMEA ?

If it does, will it take into consideration the Turn Rate (yaw) info on all Response Level setting (1, 2, 3) or will it only for setting 3 ?

Would a firmware update be required ?

Regards,
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] Autohelm T300 computer & Raymarine Smart Heading Sensor via NMEA - Sailing_Sergio - 12-14-18 03:55 PM

Forum Jump:


User(s) browsing this thread: 4 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication