[CA] [CA11] Quantum Radar not found

[Chuck - Raymarine - Moderator]

Mike,

Many are not aware that the design of the wired Quantum radome features two Wi-Fi transmitter/receivers. One is connected to the radome's wired communications interface and the other is identical to that which W-Fi - only Quantum radomes have. When interfaced to the Quantum radome via a communications cable, commands and data are passed between these Wi-Fi communications interface. It is quite possible that the root of the problem which you are experiencing with the Quantum is within its Wi-Fi receiver that is common to Wi-Fi - only Quantum radomes. Should a Quantum radome have been interfaced to the system via a communications cable, then it would be necessary to disconnect the Quantum communications cable from the MFD or network switch and then perform a Settings Reset or Factory Reset to clear knowledge of the radome from the memories of the system's MFDs. One may then attempt to pair a MFD (the one which is in closest proximity to the Quantum and/or surrounded by the least structure would be recommended) with the Quantum radome. Afterwards, whenever desiring to utilize radar features, this MFD must be switched ON.