[CA] [CA11] Axiom 9

[Bradscott]

Hi, I have the above unit and have a few problems that I can not solve.
1,
When installing manual way points when I go to save the last 3 numbers change. For eg, I enter 30 34 024S - 115 25 704E it will change to 30 34 024S 115 25 613E every time. I have also done this by using the touch screen as a close coordinate but when I went to change the 115 25 705E it also goes to the 613E?

I entered 140+ waypoints in manually 12 months ago but i did not notice this issue but I guess i will need to check them all?

The unit is running the 3.7 firmware, I have also tried a factory reset to no avail.

2,
When coming up to a waypoint the boat indicator runs over the waypoint and then after stopping, 20-30 seconds later we are approx 30m off normally short of it?

The boat is a pontoon with no cover, We have have also move all mobile devices away from the unit, this still makes no difference.
3,
Is the above issue because the icon is to big? can this be made smaller?
4,
I have checked satellites and there always seems to be 6+ with an accuracy of .9-1.5m?

Can you please give me an in site on these issues?
Thanks
Brad