Dragonfly 7 reset lighthouse chart behavior

[swadeab]

Hi, this may be a bug or something went wacky with my unit.

I just want to post this here in case anyone else gets this oddity with a dragonfly firmware upgrade.

My DF7 has been working fine. I upgraded the firmware..no problems, my lighthouse charts (downloaded to cf card still worked fine). Next day out i turned on the unit and it did some kinda of reset somehow, almost seemed like it had just 1st been started up as i had to set some preferences. Went though that and my charts were gone.

Disconnected the unit reconnected, removed cf, reinserted cf still no charts. I immediately thought microSD reader went bad, got water? did card go bad or get corrupted?

I brought the cf to my Mac to see if it could read it, all looked ok. I decided to test the microSD reader. Saved screenshot fine. I next inserted a blank microSD card into the unit to see if it would write lighthouse_id.txt , and the instructions are a bit wrong for the dragonfly. On the charts page, it says to insert a blank microSD and it will write lighthouse_id.txt..that did not happen.

Searching the forums i found lighthouse_id.txt will only get written if you turn on the DF and go the lighthouse chart screen and select the lighthouse chart base map option. I did that with my blank card. Removed card brought inside..._id.txt was there. Ok so at this point i know i’m writing to the microSD fine now.

I put the previous card in...and now it recognized the card fine, like nothing happened. I had probably inserted , turned off/on 10+ times by that point before i performed the above blank microSD lighthouse_id.txt procedure.

Could be odd. Or it could be some bug where the unit reset somehow and wouldn’t recognize an existing card *until* it had written a lighthouse_id.txt *somewhere*.

At first i was wondering if the id changed somehow on the unit but that looked fine checking the file on the original card with the newly written one.

Again could be coincidence, or an odd occurrence of events. But the DF7 with latest firmware after some odd reset would not read my microSD card until i put a new one in and wrote lighthouse_id.txt no matter how many times or steps i inserted/removed the original. Once i did that...1st time, boom it recognized my original card.

Maybe this will help someone or could be my unit, i’ll watch it and see if anything odd occurs, but since then all is working great. Thanks!