[CA] [CA11] Network with E7, Axiom and HS5

[Chuck - Raymarine - Moderator]

Peter,

A spur cable should not be used to interface the S1G to a SeaTalk to SeaTalkng Converter. The SeaTalk to SeaTalkng Converter is supplied with a SeaTalk to SeaTalkng Converter Cable (yellow plug on one end and press fit 3-pin plug on the other end). This cable will be plugged into the SeaTalk (yellow) socket of the SeaTalk to SeaTalkng Converter. If the S1G is within reach of the SeaTalk to SeaTalkng Converter Cable, then its press fit 3-pin plug will be cut off to permit the cable's yellow and shield leads to then be connected to the corresponding SeaTalk terminals of the S1G. If the S1G is not within reach of the SeaTalk to SeaTalkng Converter Cable, then its press fit 3-pin plug will be connected to a D244 SeaTalk Junction Block. An appropriate length of SeaTalk Cable having press-fit 3-Pin Plugs on each end will then be connected to the D244 SeaTalk Junction Block and will run to the S1G's SeaTalk port. As would have been the case for the SeaTalk to SeaTalkng Converter Cable, the SeaTalk Cable's press-fit 3-pin plug will be cut off to permit the cable's yellow and shield leads to then be connected to the corresponding SeaTalk terminals of the S1G.