Raymarine forum / Raymarine Forums / Instruments v / [TG] [TG11] ST60+ Low Depth Alarm Setting Blocked?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] ST60+ Low Depth Alarm Setting Blocked?
01-17-19, 09:42 PM (This post was last modified: 01-20-19 08:09 AM by Chuck - Raymarine - Moderator.)
Post: #2
Tom - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,067
Joined: Nov 2017
Reputation: 7
RE:[TG11] ST60+ Low Depth Alarm Setting Blocked?
Hello Dave,

You can only configure alarms on the device that provides the data: is the depth transducer connected to the ST60+ Depth, or the A70D? If the latter, you need to configure the alarm on the A70D. Note that alarms aren't necessarily passed through convertors.

Also: convertors plural? You should only have 1. More than one convertor implies two separate ST1 or STNG networks, which can cause all sorts of data problems including data loops. You should have a single ST1 network, a single STNG network, and a single point of connection.

Regards,
Tom
Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE:[TG11] ST60+ Low Depth Alarm Setting Blocked? - Tom - Raymarine - Moderator - 01-17-19 09:42 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication