Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [[CA11] Axiom MFD with Camino-108 AIS
01-24-19, 01:36 PM (This post was last modified: 02-04-19 09:05 AM by Chuck - Raymarine - Moderator.)
Post: #4
RE: [[CA11] Axiom MFD with Camino-108 AIS
Tenedos,

IMO states that a broken line around the target symbol should be rendered if a collision avoidance computation cannot be performed. This condition may occur if heading or COG is not included within the received AIS data or if there is some uncertainty with regard to the position and COG of one's vessel. I recommend that you examine the data for each AIS target via the MFD's AIS target list when this condition is observed. It is also recommended that you examine the GPS Status dialog to determine whether the MFD is reporting that it has acquired a GPS position FIX and that its HDOP is relatively low. A properly functioning GPS receiver, GPS antenna, or GPS sensor which has been afforded an unobstructed view of the skies overhead will typically yield a HDOP of 1.0 or less. Also, should you find information differing from that which has been specified within this response, then please attach a screen snapshot of the MFD's AIS Target List and additionally attach a screen snapshot of the MFD's Chart application which has been configured to display the Infobox alongside the AIS target. Please additionally attach a screen snapshot of the MFD's GPS status dialog.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [[CA11] Axiom MFD with Camino-108 AIS - Chuck - Raymarine - Moderator - 01-24-19 01:36 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)