[CA] [CA11] Raymic and Ray55

[JT101]

I just connected a new Raymic to a newer Ray55. The only sound I get out the Raymic is an occasional crackle or pop. The Ray 55 sounds good. The system test says Raymic OK. The Raymic buttons and display all seem to work fine. The raymic volume control does change the volume of the crackle and pop. I checked to see if I had the right part number Raymic. I checked all the connector pins on both ends and they look good. The only problem clue I found was the connector plug threaded backshell/clamp on the Ray55 end refuses to thread onto the jack side. The connection seems to be aligned and fully engaged.