The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Autopilot tiller arm on a C&C Landfall 38?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Autopilot tiller arm on a C&C Landfall 38?
02-16-19, 10:39 AM (This post was last modified: 02-20-19 10:04 AM by Chuck - Raymarine - Moderator.)
Post: #1
svviolethour Offline
Junior Member
**
 		Posts: 3
Joined: Jan 2019
Reputation: 0
[CA11] Autopilot tiller arm on a C&C Landfall 38?
I'm considering buying an EV-200 autopilot system for our C&C Landfall 38 sailboat.
But installing a tiller arm on these boats is problematic. Does anyone know of successful installs on this model boat, or have advice for tiller arm placement on similar boats with very limited rudder shaft space? Or know any Raymarine dealers with experience in tight tiller arm placements?

There's only a couple inches above/below the Edson radial drive and I'm not sure it will be enough. I'd like to avoid the hack of bolting the autopilot ram to the radial drive, which is strongly discouraged by Edson (some people have done it anyway, but it's certainly not optimal).
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Autopilot tiller arm on a C&C Landfall 38? - svviolethour - 02-16-19 10:39 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication