[CA] [CA11] Axiom Pro S transducer compatibility

[cc driver]

The Axiom Pro 12 S (E70482) manual states that, “only CPT-S series transducers can be connected to Axiom Pro S variant MFDs” and it goes on to indicate that an adaptor cable (A80490) is needed to make the connection between the Axiom Pro S MFD and the CPT-S transducer. In this same manual, there is no mention of connecting to a sonar module. In the CP470 CHIRP Sonar Module manual however, there is a chart in section 3.3 that indicates compatible MFDs and the Axiom Pro S variants are cited as being compatible. So, the questions are, can a CP470 CHIRP Sonar Module be used with an Axiom Pro S variant MFD? If so, what connection would be used between the Sonar Module and the Axiom Pro S MFD? Does each device merely connect to the NMEA2000 backbone via Seatalkng adaptor cables? If not, then what?

Thanks!