Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] Upgrading from E7 to Axiom 9 - cables/converters needed?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Upgrading from E7 to Axiom 9 - cables/converters needed?
02-25-19, 07:53 PM (This post was last modified: 02-26-19 07:27 AM by Chuck - Raymarine - Moderator.)
Post: #11
scottotheforest Offline
Junior Member
**
 		Posts: 11
Joined: Feb 2018
Reputation: 0
RE: [CA11] Upgrading from E7 to Axiom 9 - cables/converters needed?
A few more hours spelunking, but found the Autohelm computer for the ST7000+.
Hi res photo too big to upload but can be viewed here: https://photos.app.goo.gl/SzhQQcFeFduwXndi8

to see what connections are used on the wiring terminal block. One of the two sets SeaTalk cables had been cut. The other presumably is intact to the ST7000+.

Now since I've only powered up the Axiom 9 and haven't configured or updated the software yet, perhaps when that's done the Axiom will see the Autohelm in the onscreen network anyway?

If not, any advice on how to get them to talk nice to each other and if the Axiom routes can be followed would be fabulous Chuck.

Long process and thanks for your patience. Learning lots at my.end anyway!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication