[TG] [TG11] Upgrading from a Wheel Pilot

[Tom - Raymarine - Moderator]

Hello Duncan,

Alongside the drive, you'll also need to change the electronics that provides the drive output to that drive.

6 years ago we were changing over from the then-retiring SPX range to the new Evolution range so you could have either electronics in your system (p70 and wheeldrive will work with either generation.) We don't have any stock of the SPX range any longer, so if that's what's on board then you'll need to upgrade (and it is a significant upgrade) to the Evolution range. This means changing the SPX course computer to an Evolution ACU and also changing the fluxgate compass for the EV1 solid-state heading sensor core. Or, of course, sourcing a second-hand SPX model.

There are two main options as far as drive type goes: Linear or Rotary. Linear drives acting directly on the quadrant are preferable, but are only suitable if you can back-drive the steering: that is, if you shove the quadrant, the wheel spins freely. This isn't always the case, and if the steering just goes tight and locks up when you push the quadrant then you'll need a rotary drive instead which connects via a chain to an additional sprocket at the base of the binnacle.
As well as the drive design, there is also a choice to be made about the drive power. We do Type 1 drives that are suitable for a *fully laden* displacement of 10,000kg (fully laden displacement on cruising boats is often at least 20% above the design or published weight) maximum, less if the system's being used for extended short-handed passage-making or offshore. After a Type 1 drive there's a Type 2, and then Type 3. At a guess based on the size I'd say you're likely to be on the upper limit for a T1, more likely a T2, but the weight on the travel-lift when she last was lifted is the real guide. I would always recommend going one bigger if you're going to be using the drive offshore (can't run for port when the sea picks up) or short-handed using the pilot for long periods.

If you can get away with a T1 then you can use an SPX10 (retired generation) or ACU200 (current, alongside EV1 sensor), whereas if you need a T2 drive then that requires an SPX30 or ACU400 (which can supply the extra current that the more powerful drives require.)

For either set of electronics the p70 can remain, and if you have an Evolution pilot (EV-100 Wheel) now then the EV1 also remains.

To find out what electronics you have now, look in Menu > Setup > Diagnostics > About System.

Regards,
Tom