Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] "Current Limit" st6002
02-27-19, 08:31 AM
Post: #3
RE: [CA11] "Current Limit" st6002
I'll make the "Current Limit" error even more complicated. LOL...

I've read Chuck's diagnostic tests, etc. And, in full disclosure, I have *not* performed them - yet - but plan to.

Here's my question.

In my case, I turn on the boat, and I get no error on my ST800x (forget which one I have)...

Then in about 30 seconds, like the previous poster mentioned, I get the "Current Limit" error.

I run the boat for a little while... the error goes away, and the autopilot works flawlessly.

My thought is this. I have a dual station, dual steering piston power catamaran. I wonder if air at the pump could be an issue? If not, then what.

The batteries (4 31 series) are all on a Noco charger and all in good condition.

E120 Classic (Master) & E80 Classic (Upper Station) - 10KW 4' Open - DSM300 w/Airmar M260 - S1 AP (Type 1 Pump) w/8002 & 6002 - SeaTalkHG - And... lots and lots of wire and boxes. :-)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] "Current Limit" st6002 - Plan B - 02-12-19, 02:37 AM
RE: [CA11] "Current Limit" st6002 - OldPete - 02-27-19 08:31 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)