Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] New Axiom Install

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] New Axiom Install
03-11-19, 07:58 AM
Post: #6
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] New Axiom Install
Q1. If I am understanding what I am reading in your response, I need to cut and insulate the red wire that goes from the ST7000+ to the Type 400 course computer. is that correct?
A1. Negative. I am suggesting that you will need to create two SeaTalk busses, one for the control head and remote. The other will be for the instruments and connection to the ST-ST1 Converter.
----- SeaTalk bus 1: ST7001<->ST600R<->Course Computer ST Port #1 (connect all leads of SeaTalk cable to course computer)
----- SeaTalk bus 2: ST-STng Converter<->ST60<->ST60<->ST60<->Course Computer ST Port #2 (connect only yellow and shield leads of SeaTalk cable to course computer)
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] New Axiom Install - TJ Champion - 03-07-19, 12:31 PM
RE: [CA11] New Axiom Install - Chuck - Raymarine - Moderator - 03-11-19 07:58 AM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication