EV200 compatibility with Garmin 7610xsv

[esveden]

Hello, I recently purchased and installed a new electronics system for my 04 Scout 280 Abaco with twin Yamaha F225 outboards. The installation when smoothly and I tested it for the first time and everything appears to be working perfectly with one exception. The AP steers under Power Steer, but doesn't recognize the GPS data so won't track. All other functions appear to work.

The brand new system is all NMEA2000, everything in the entire system was replaced aside from a VHF radio. The system includes:

*AP - Raymarine EV200 Power Pilot T70156 (included P70R head), Raymarine Type 1 pump 12V M81120, Raymarine SeatalkNG to NMEA2000 Male adapter cable A06046

*Chartplotter/Radar - Garmin 7610xsv, Garmin 18xHD radar, Garmin GT52HW-TM transducer, Garmin NMEA 2000 starter kit.

The Garmin 7610xsv recognizes all the Raymarine equipment, but the P70R head doesn't appear to recognize the GPS data.

Again, other than tracking, everything else appears to be working flawlessly (although I could use a hand with the "hard over steer" setup...it's the only thing I haven't figured out....I did not install the rudder sensor as I'm running outboards and there's no room).

I assume this is a setting, or perhaps I need to reconfigure where power comes in to the N2k/SeatalkNG system. I've attached a very basic wiring diagram for your review.

Thanks very much for your anticipated support!

Erik Sveden