[CA] [CA11] eS series to Axiom Connection

[MSjack]

Thanks again Chuck - so just to make sure I have this right:

Your answer was -
A1. Please note that within an Ethernet network of MFD, the SeaTalkng / NMEA 2000 port will only be active on the MFD which has been designated as the system's Data Master MFD. Accordingly, the MFD which one intends to function as the system's Data Master MFD must be interfaced as a spur to the system's powered and properly terminated SeaTalkng / NMEA 2000 backbone. The WiFi and NMEA 0183 ports of these MFDs are active on each of the system's MFDs.

New Q1 - So... I will set the Axiom unit to the data master and basically disconnect the existing NMEA 2000 spur cable from my eS unit and route it to the new Axiom? (I will be mounting them side by side so that will be easy)

New Q2 - At this point the eS unit that is networked via Ethernet to the master Axiom will not have any NMEA 2000 connection but my NMEA 0183 output from my eS unit to VHF will still function?

Just trying to make sure I have this correct.