[CA] [CA11] SmartController shows NO PILOT on display

[hynespa]

Hi Chuck,

My SmartController E15025 was previously working but now shows “NO PILOT” on the display. The S3G autopilot computer and P70R autopilot controller are otherwise working (S3G), and autopilot control from the eS127 MFD also works normally.

I tried following the instructions in the SmartController instruction manual to deregister and reregister with the base station. It finds the base station and successfully reregisters, but still displays “NO PILOT”. Any other steps I can take to troubleshoot?

I have attached a PDF showing the full wiring diagram and setup of my Raymarine systems.

Thanks,

Patrick