Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Verifying NMEA cable function - AIS not communicating

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Verifying NMEA cable function - AIS not communicating
03-22-19, 06:25 AM (This post was last modified: 03-25-19 10:05 AM by Chuck - Raymarine - Moderator.)
Post: #7
andyschoenb Offline
Junior Member
**
 		Posts: 14
Joined: Apr 2018
Reputation: 0
RE: [CA11] Verifying NMEA cable function - AIS not communicating
Hello Chuck,
I replaced the NMEA 0183 cable, and then wired up the two E80's. I now get AIS signals on both, however I get a different icon in the top right corner of both displays (picture attached). Since I am seeing AIS targets on both displays, the red X on the icon gave me concern. Reading the E80 manual there is no correlative icon to what I am seeing, however I believe it is indicating that yes the E80 is receiving signal from the AIS but that "Dangerous Target Alarm" is turned off. It could mean something else and that is why I am requesting your input before I claim complete success with this forum issue.
Thank you again for your help
Andy
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Verifying NMEA cable function - AIS not communicating - andyschoenb - 03-22-19 06:25 AM

Forum Jump:


User(s) browsing this thread: 4 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication